FRP grating production process considerations Source: www.hbgjfrp.com FRP Grating FRP grating fabrication process of the project note one thing, first of all, in the use of molded fiberglass grating facilities before FRP Grating FRP grid, the demand for facilities the implementation of the various components of seizing all aspects carefully, to ensure the normal use of facilities. 1, the operation of skilled workers must master the making technology, if novices, need technical and political instructor training about half the purposes of training, the ability to official posts. 2, in the manufacture of molded grating before mixing the raw material needs a good tune for a long while before use, after a long while to use the material at any time ditty good tune. 3, in the process of mixing the raw material, be sure to pay attention to the tone mixed material according to the prescription dispensing method to be reasonable, in order to meet product standards. Second, when all of the preparation work back end, it can be implemented molded grating fabrication, manufacturing should be noted at the time: an operator skilled workers must master basic grille molding processes and techniques during the operation; Whatever attention to the manufacturing process of a small detail, the ability to further increase the quality of FRP grating. 2, skilled workers to operate slowly molded grating for the basic needs of process techniques, practice makes perfect, especially in the process of pulling the yarn to grasp the whole health of a good amount of power the ability to further grow enough to grill plate. 3, during operation with a good grasp of every detail, every little detail is very large effect, every detail is very bad for the integrity of conduct will result in a direct impact on the quality of glass and steel grille. 4, the most important is a little pressure in the artificial yarns moment, be sure that the pressure groups in exactly the same degree of yarn capacity standards. Third, when the FRP grating manual operation is complete, the next condensation heating demand, a good grasp of proper water temperature and valve switching. Wait until the end of the grill plate condensation, you can start working facilities at the bottom rise up button to complete the grid plate and eventually get rid of the office molding facility. Fourth, the final also note that for the purposes of molded grating facilities should be cleaned regularly in order to increase the use of facilities of life and the appearance of FRP molded grating survival of Guangliu degrees. http://www.hbgjfrp.com/news/hy/144.html